What you need
- A 9V battery or 2 × AA batteries in a holder
- 2–3 small bulbs in holders, or LEDs (5 mm)
- 4–6 insulated wires with alligator clips
- Aluminium foil and tape (if you don't have wires)
- Optional: a paperclip and two brass paper fasteners to make a switch
Everything here can be found at home or in a supermarket.
- Use only small batteries (AA, AAA or 9V). Never use mains electricity or wall sockets.
- Don't connect a wire straight from + to − with nothing in between — it makes the wire and battery hot.
- If using LEDs, add a small resistor (around 220 Ω) or use a coin cell so the LED doesn't burn out.
Step by step
- Connect one wire from the battery's + end to one side of the bulb holder.
- Connect a second wire from the other side of the bulb back to the battery's − end. The bulb lights — you've made a complete loop, called a circuit.
- Unclip one wire. The light goes out. A circuit must be a closed loop for electricity to flow.
- Add a second bulb in the same loop, one after the other (series). Are the bulbs brighter or dimmer than one bulb alone?
- Now rebuild so each bulb has its own path to the battery (parallel). Compare the brightness again.
- Unscrew one bulb in each circuit. In which circuit does the other bulb stay lit?
Try it online first
Not ready to get messy? Test your ideas in our free online lab, then try the real thing.
Circuit Builder Lab
- Voltage
- 1.5 V
- Total current
- 0.50 A
The science behind it
🧒 For kids
Electricity flows like water in a loop of pipe. The battery is the pump. The bulb is like a water wheel that the flow has to push through — that push makes it glow. Break the loop anywhere and the flow stops.
🧑🏫 For grown-ups
In series, bulbs share the battery voltage and the same current flows through each, so each bulb gets less power and glows dimmer; one failure opens the whole circuit. In parallel, each bulb receives the full battery voltage, so each glows as brightly as a single bulb, but the battery supplies more total current and drains faster. This follows Ohm's law (V = I × R) and P = I²R.
Take it further
Change one thing at a time and see what happens. That's how real scientists run a fair test.
- Make a switch from a paperclip and two paper fasteners and add it to your circuit.
- Test materials as conductors: put a coin, eraser, spoon, pencil lead and plastic straw into a gap in the circuit.
- Design a circuit where one switch controls two bulbs, and another controls just one.
Questions kids (and parents) ask
Why are bulbs dimmer in series?
The battery's voltage is split between the bulbs, so each one gets only part of the push and receives less power.
Are LEDs better than small bulbs for kids?
LEDs use less power and stay cool, but they only work one way round (the longer leg goes to +) and need a resistor with most batteries. Small torch bulbs are more forgiving for a first circuit.